If there is a burr or bump or something else on the tab, file it off with a small, flat metal file to smooth out the surface of the tab. If the end of the hook is not bent, it may have a metal burr that is left over from when the tab was made. There is a slot cut into the tape measure calibration tool that is meant to help you bend the tab end in or out to make the measurement accurate. If the pull measurement is off but the push measurement is good, the hook tab may be bent. However, if the marks are way off, there are a few things you can do to make the tape measure work accurately. If the marks on the tape measure line up with the laser etch marks on the calibration tool according to your standards, there is nothing else you need to do. They are etched on the tool at 10 mm and 6 inches. Place the tape end tab in the calibration slot and check the measurements printed on the tape against the lines laser engraved into the tape measure calibration tool. Calibration ProcedureĬheck the push and pull measurements of your tape measure (they should remain the same) with a tape measure calibrator. The tool to use to calibrate tape measures is appropriately called a tape measure calibrator, and they are available online or through specific brick-and-mortar retailers. The correct position is different for each tape measure, so it is important to have one tool to calibrate multiple tape measures. When a tape measure is calibrated to measure the correct distance, the tab at the end of the tape measure is set to the correct position. Measurement accuracy must be measured regularly in order to be sure your tapes do not begin to measure incorrectly. It helps to have a tape measure calibrated so that it measures the correct distance every time. If you have the right tools for the job, you can accomplish anything.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |